The Ford Barn - View Single Post

Viv W · 10-16-2020, 12:31 PM

Hi Tom
I think in the factory the dashboard rubber grommet was fitted on the knob end and then that sleeve was crimped into place.
I also could not figure how to crimp it back together with a new sleeve, so in the end I drilled a hole thru the sleeve and the rod and have fitted it together with split pins about half the diameter of the choke rod. It works a treat.
Viv.

10-16-2020, 12:31 PM	#2
Viv W Senior Member Join Date: Feb 2014 Location: Harare Zimbabwe Posts: 160	Re: connector sleeve for choke rod Hi Tom I think in the factory the dashboard rubber grommet was fitted on the knob end and then that sleeve was crimped into place. I also could not figure how to crimp it back together with a new sleeve, so in the end I drilled a hole thru the sleeve and the rod and have fitted it together with split pins about half the diameter of the choke rod. It works a treat. Viv.