Thread: GAV leaking
View Single Post
Old 08-19-2020, 03:08 PM   #5
cederholm
Senior Member
 
cederholm's Avatar
 
Join Date: Jun 2017
Location: Brooklyn NYC
Posts: 280
Default Re: GAV leaking

Awesome, thank you.

Quote:
Originally Posted by ryanheacox View Post
You want the gas level ~5/8" below the gasket, some like 15/16". A good rule of thumb is to have the seam of the float at an even 1" from the casting with the upper half flipped upside down. This info is all for the Zenith. You also want the cap jet to have a depth of 7/16" from the machined surface of the lower half and the main jet to have a depth of 3/8".
cederholm is offline   Reply With Quote