Re: Model A cracked block
If it were possible. You might be able to avoid heating it by cleaning the area, JB weld (epoxy) a patch over it and drill a series of small holes around the edge, then tap for very small bolts.
That's the sort of thing i'm forced to do. It's not as bad as people think.
__________________
<Link> This is how we roll<Link>
"I'm Convinced that no one really reads posts anymore; they just fabricate what they think the post says then ramble on about red herrings."--Bob
Outcasts rules of old cars
#1 Fun is imperative, mainstream is overrated
#2 If they think it is impossible, prove them wrong
#3 If the science says it impossible you are not being creative enough.
#4 No shame in recreating something you never had
#5 If it were not for the law & physics you would be unstoppable
|