The Ford Barn - View Single Post

CT Jack · 02-18-2020, 10:01 PM

Conaway is correct. Buy a new clutch & pressure plate, resurface the flywheel and have them balanced as a unit. Replace the pan gasket and the front upper and lower crank seal which is included in the gasket set. Oil leaking at the front end of the pan is usually caused by a leaky front seal.

02-18-2020, 10:01 PM	#5
CT Jack Senior Member Join Date: May 2010 Location: Hebron, CT Posts: 432	Re: Switching Engine, Reusing Flywheel Conaway is correct. Buy a new clutch & pressure plate, resurface the flywheel and have them balanced as a unit. Replace the pan gasket and the front upper and lower crank seal which is included in the gasket set. Oil leaking at the front end of the pan is usually caused by a leaky front seal.