The Ford Barn - View Single Post

Benson · 06-23-2018, 11:39 AM

About noise:

1. Maybe Float a motor engine mounts with hard rubber or compressed and mount hitting each other?

2. Rear transmission mount above the U Joint that is bottoming out on cross member due to problem with rear Float A Motor mount?

3. Front motor mount with wrong hardware?

a. JC Whitney spring setup or yoke nut too tight?

b. spring coils too large or springs too long so coils are binding when nut is tight?

06-23-2018, 11:39 AM	#23
Benson Senior Member Join Date: May 2010 Posts: 2,592	Re: Mitchell Over Drive 26% or 36% About noise: 1. Maybe Float a motor engine mounts with hard rubber or compressed and mount hitting each other? 2. Rear transmission mount above the U Joint that is bottoming out on cross member due to problem with rear Float A Motor mount? 3. Front motor mount with wrong hardware? a. JC Whitney spring setup or yoke nut too tight? b. spring coils too large or springs too long so coils are binding when nut is tight? Last edited by Benson; 06-23-2018 at 11:50 AM.