The Ford Barn - View Single Post

RockHillWill · 09-23-2014, 09:20 AM

Been making more progress on the tooling that I am expecting to use to put more character lines in the speedster panels. These are some layout pictures that I have been making to be able to use a bead roller in the hand held position to be able to use on panels that are still attached to the car. It is similar to a tool that I saw in a Cass Nawrocki book. It's nothing more than a set of bead rolls powered by a 3/8" drive air ratchet

Pic1.JPG

Pic2.JPG

Pic3.JPG

Pic6.JPG

09-23-2014, 09:20 AM	#77
RockHillWill Senior Member Join Date: May 2010 Location: Rock Hill, S.C. Posts: 985	Re: I could not sit idle, have a new project Been making more progress on the tooling that I am expecting to use to put more character lines in the speedster panels. These are some layout pictures that I have been making to be able to use a bead roller in the hand held position to be able to use on panels that are still attached to the car. It is similar to a tool that I saw in a Cass Nawrocki book. It's nothing more than a set of bead rolls powered by a 3/8" drive air ratchet Pic1.JPG Pic2.JPG Pic3.JPG Pic6.JPG __________________ Uncle Bud says "too soon old, too late smart!"