Re: Decided to pull the motor/trans
Pulled the floor to fix trans leak and found that it was leaking because I hadn't tightened the bolts in the shift tower. Also found out why the leak was getting progressively worse. Figured that since it was laking the trans would be low so i pulled the filler plug to top it up and found that, in fact it was over full with a mixture of oil and grease. Obviously the corn head grease that I put in the ujojnt is going through the bearing into the trans. No wonder it was easy to shift. drained the "oil" from the trans and refilled. Will have to monitor it I guess. Not sure what is the best route to take on the joint. Let it find it's level?, put chassis grease in it?, remove the CH grease first? (not sure how to do that). Might have just put way too much and forced it into the trans (took just over a tube).
|