The Ford Barn - View Single Post

modelamotorhead · 05-03-2018, 12:44 AM

Building a '30 OCPU utilizing a new Brookville cab. I'm at the point of setting the new seat springs in the cab to test fit them. I understand how the seat cushion mounts, but can't figure out how the seat back mounts. I checked Mac's and they show mounts for CCPU models only. The Brookville cab has three vertical ribs bolted to the tub and lower rear of the seat riser, are these ribs what I attach the seat back springs to? I would fabricate or buy the mounts if I only knew what they looked like and where they are to be located. This is my first OCPU build and any tech help or pictures of original seat back mounts would be greatly appreciated.

05-03-2018, 12:44 AM	#1
modelamotorhead Junior Member Join Date: Feb 2011 Location: Spokane, WA Posts: 14	1930 Open Cab Pickup seat back mounting Building a '30 OCPU utilizing a new Brookville cab. I'm at the point of setting the new seat springs in the cab to test fit them. I understand how the seat cushion mounts, but can't figure out how the seat back mounts. I checked Mac's and they show mounts for CCPU models only. The Brookville cab has three vertical ribs bolted to the tub and lower rear of the seat riser, are these ribs what I attach the seat back springs to? I would fabricate or buy the mounts if I only knew what they looked like and where they are to be located. This is my first OCPU build and any tech help or pictures of original seat back mounts would be greatly appreciated.