The Ford Barn - View Single Post - Question on Cam Gear Marks

Russ/40 · 09-29-2020, 10:05 PM

No I have not. I only have the manifold single ports vacuum sources, not a central vacuum. The timeing is so off, I not sure that would be worthwhile. When I get the timeing issue resolved, I'll do a compression check. If that falls short, I'll do a leak down test. Timeing is the first issue of importance in my mind.

09-29-2020, 10:05 PM	#19
Russ/40 Senior Member Join Date: May 2010 Location: Santee, California Posts: 3,505	Re: Question on Cam Gear Marks - UPDATE No I have not. I only have the manifold single ports vacuum sources, not a central vacuum. The timeing is so off, I not sure that would be worthwhile. When I get the timeing issue resolved, I'll do a compression check. If that falls short, I'll do a leak down test. Timeing is the first issue of importance in my mind.