The Ford Barn - View Single Post - Installing Model A Ford == D == Shaped Nuts

Roadster62 · 05-13-2010, 03:34 AM

FINISHED! Wire and a MIG welder worked just fine. I'm not a MIG welding fan, but have to admit in this case it was the right tool for the job. Now if someone could post an inside photo of a 30-31 Ford Coupe/Roadster trunk I can move onto the next problem, the inside rear tin.

05-13-2010, 03:34 AM	#10
Roadster62 Senior Member Join Date: May 2010 Location: Ridgefield, Ct Posts: 3,441	Re: Installing Model A Ford == D == Shaped Nuts FINISHED! Wire and a MIG welder worked just fine. I'm not a MIG welding fan, but have to admit in this case it was the right tool for the job. Now if someone could post an inside photo of a 30-31 Ford Coupe/Roadster trunk I can move onto the next problem, the inside rear tin.