08-16-2021, 04:03 PM
|
#23
|
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,852
|
Re: Hole in front of Engine block-UPDATE
Quote:
Originally Posted by alundsberg
First, thanks for all of the replies and suggestions.
Since I don't have an engine hoist, I decided to go the easy route and grind it all down and use an epoxy again. This time I used Belzona 1212 with some fiber mesh as a patch. Supposedly much better than JB Weld.
So far so good... although it doesn't look pretty but she runs and that's all that matters! If I can get another 10+ years out of it with no leaks, I'll be shocked.
Picture:
https://appriver3651016241-my.sharep...tDZTA?e=DkmDGh
Video:
https://appriver3651016241-my.sharep...WK_OQ?e=ULqBnl |
Good Job!! Sand it and paint it. Most people will not even notice it these days... 
Side note, looks like you have a lot of sediment in your sediment bowl.
Last edited by Y-Blockhead; 08-16-2021 at 04:14 PM.
|
|
|