Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by 170bdlx
I am rebuilding three carbs and need some advice about the main and cap jets. I see that both jets should be at the same level in the lower body at the narrowest point in the venturi. All three of mine are not when one washer is added tom each. The main jet is higher on all three carbs. It takes three washers on the main jet to make it level with the cap jet, then they are level and seem to be at the correct point on the venturi. Is this normal?
|
Only one washer per jet!! Idle jet NO washer. Make sure there are not other washers in the seats.