The Ford Barn - View Single Post

Bluebell · 08-28-2013, 07:47 PM

Some of you might like to consider this thought.
Does anyone know of any manufacturer that does NOT recommend working from the center of the head out, when either fitting or removing a cylinder head? (I can't think of one)

I like a lot of speedways recommendations, in those instructions, but that bit about the tightening sequence seems like a lemon to me.

08-28-2013, 07:47 PM	#12
Bluebell Senior Member Join Date: Nov 2012 Location: Tauranga, New Zealand Posts: 726	Re: torquing Offenhauser heads Some of you might like to consider this thought. Does anyone know of any manufacturer that does NOT recommend working from the center of the head out, when either fitting or removing a cylinder head? (I can't think of one) I like a lot of speedways recommendations, in those instructions, but that bit about the tightening sequence seems like a lemon to me.