The Ford Barn - View Single Post

19Fordy · 06-07-2020, 10:03 PM

I would think that it would be a good idea to fill in the hollow end of the pin with "weld" so as to make it solid before swedging. Steel rivets are usually solid.

06-07-2020, 10:03 PM	#15
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,973	Re: Drive shaft lock pin I would think that it would be a good idea to fill in the hollow end of the pin with "weld" so as to make it solid before swedging. Steel rivets are usually solid.