View Single Post
Old 07-08-2020, 02:01 PM   #3
Kube
Senior Member
 
Kube's Avatar
 
Join Date: May 2010
Location: Wisconsin, USA
Posts: 6,388
Default Re: Handle escutcheon installation

Quote:
Originally Posted by HDowse View Post
I suspect we've all had some difficulty trying to push the door handle or window crank escutcheon in far enough to remove and then replace the pin that holds the handle to the shaft. I have the Drake tool but it's a bear to push the escutcheon in far enough to get the pin out. Even worse is trying to get the pin back in when replacing the escutcheon or pulling the door panel. I figured a little mechanical advantage would make the job a lot easier.
See the photos to understand how the brace across the opposite door opening works along with the cross brace that lines up with the handle in need of service. I fit a vertical for height adjustment, a block to catch the expanding clamp and two spring clamps to hold the Drake tool. After lining everything up it was easy to expand the clamp and move the tool against the escutcheon and drop the pin in. Total construction time was about a half hour, all parts were on hand.
And I thought I over engineered things!
I had purchased one of those tools from drake. It was / is a good little tool. I use my waist to apply pressure to the tool while leaving both hands free to remove or install the pin..
__________________
"I can explain it for you. However, I can't understand it for you".
Kube is offline   Reply With Quote