View Single Post
Old 05-27-2020, 05:42 PM   #6
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 880
Default Re: Engine inspection (with pics)

Sponsored Links (Register now to hide all advertisements)
I pulled the valves. The guides were shot. I didn't take any measurements but they were quite sloppy. Without removing a piston, there is quite a bit of play at the top of the pistons side to side when I bring them up to the top. Not sure what to make of than as it seems to me that if the cylinders were wore it would show with a ridge at the top. Unless it was bored wrong or maybe this is normal for these engines, I don't know.
Licensed to kill is offline   Reply With Quote