View Single Post
Old 08-10-2019, 08:37 AM   #1
Senior Member
History's Avatar
Join Date: Oct 2017
Location: NC Mountains
Posts: 457
Default Flared copper washers for gaskets?

I posted this video link in another thread because I thought it was a great idea?? No one responded so I don't know if that's good or bad, the thread was almost at it's end.

What do you pros think of this as a fix for the flared gas lines that go from gas shut off valve to the firewall side of the sediment bowl or any flared fitting for that matter? I've read that the original flare is different than most flaring tools that people have. One of my lines had thread wrapped around the back of the flare to add more pressure (I ASSume). Seems like a great idea to me still??

Is there a way to embed videos here instead of a link?

Last edited by History; 08-10-2019 at 08:57 AM.
History is offline   Reply With Quote