Thread: Insert bearings
View Single Post
Old 01-31-2017, 10:58 PM   #11
CT Jack
Senior Member
 
CT Jack's Avatar
 
Join Date: May 2010
Location: Hebron, CT
Posts: 209
Default Re: Insert bearings

I have to ask Dave from MN a question. Is it possible the machinist preparing the block for the inserts didn't install the proper dimensions for a good fit for the OD of the inserts?Taking this possibility into consideration along with a tight bearing fit initially and also maybe the engine wasn't dynamically balanced properly could have all contributed to the failure. If this did happen it had nothing to do with the inserts.
CT Jack is offline   Reply With Quote