Sponsored Links (Register now to hide all advertisements)
hi guys]
Back again. Sorry for intermittent posts but my battery died and I had to get a replacement. Luckily for me it was under warranty. Any way - a lot of info in the posts above and I really appreciate the help. Let me recap where I am on this thing...
1) Unscrewed cable/coil wire from the distributor - then screwed it in 3 turns
2) Using a test light and a meter on all connection
3) Power at ignition switch, terminal box, coil, and lower plate
4) Took a piece of card board, stuck it between the points - no light on test light and no reading on meter
5) This a brand new Nu-Rex set up so I doubt the condenser is bad
So what do i do from here? Read Les's manuals several times
Thanks