The Ford Barn - View Single Post

dave in australia · 09-15-2020, 05:23 AM

One of my way earlier posts was on how I repaired some of my radius rod ball and spares.
I milled the ball off, leaving a .750" shaft. Threaded the shaft to .750" UNF, then bought a ball, drill and tapped it to suit. Then screwed the ball on with loctite, and as a last securing agent, drill down the thread and inserted a roll pin.

09-15-2020, 05:23 AM	#10
dave in australia Senior Member Join Date: May 2010 Location: Victoria, Australia Posts: 1,177	Re: Radius ball cap One of my way earlier posts was on how I repaired some of my radius rod ball and spares. I milled the ball off, leaving a .750" shaft. Threaded the shaft to .750" UNF, then bought a ball, drill and tapped it to suit. Then screwed the ball on with loctite, and as a last securing agent, drill down the thread and inserted a roll pin.