I just had these EAB heads blasted and plan to have them milled for ~0.050" clearance after measuring with my block (in progress). A few of the chambers show some moderate pitting though. Is this OK or should I seek out a nicer set? The combustion chambers range from 68-71cc. Thanks!! Ken
Click the images for higher resolution
BF8E9D00-A127-48E4-A35C-CCA328BAB033 by
kenhenry_06268, on Flickr
E633D7A2-85F2-47D8-AED2-DF3131844C7C by
kenhenry_06268, on Flickr
B774E442-88BE-4F57-8291-852A87BEC30F by
kenhenry_06268, on Flickr
E0D9CCE5-B763-4A46-8030-2502560FBB11 by
kenhenry_06268, on Flickr
73F1519B-0EB7-4067-8443-97382B7C3173 by
kenhenry_06268, on Flickr