11-14-2020, 07:48 PM
|
#31
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,849
|
Re: Head gasket?
Quote:
Originally Posted by Y-Blockhead
Just curious. When you spray copper cote on your gasket what do you do about the overhang of the gasket due to the 5.5 head being physically smaller than a stock head/head gasket? I suppose you could mask it off?
|
Quote:
Originally Posted by 1crosscut
Not that much of it that shows and it hasn't been an issue to me.
|
I thought maybe you would trim the gasket since you want to "keep the outer edge clean leaving a crisp white gasket edge" instead of leaving ⅛" of gasket hanging out with sticky Copper Cote on it. Guess not...
I think I will continue to not use Copper Cote.
|
|
|