The Ford Barn - View Single Post

Richard in NC · 06-26-2010, 07:41 AM

I took a stock exhaust system, drilled a 3/8" hole where the tailpipe bent starts. Use a long sharpened rod to knock several holes in the baffles. Then you weld a small patch over the access hole. Sounds good.

06-26-2010, 07:41 AM	#11
Richard in NC Member Join Date: May 2010 Posts: 89	Re: Exhaust I took a stock exhaust system, drilled a 3/8" hole where the tailpipe bent starts. Use a long sharpened rod to knock several holes in the baffles. Then you weld a small patch over the access hole. Sounds good.