Re: 1941 Ford Pickup frame-off restore for the next generation
Decided to try and lower it myself with what is available in my garage.
Homemade spring spreader to relieve some pressure, jackstands under frame, and jack on hub.
Was able to remove original (aftermarket) shackles with no trauma involved.
Local lumber yard 1_1/2" x 1/4" x 36" metal, cut in quarters and holes drilled, one side 1/2" for the sweg stud, other side 3/8" for threaded end. Used the original studs from the aftermarket shackles.
Raised rear end, slipped in new shackles, Start to finish under 4 hours.
Drove it a couple miles, rode perfect, with no noticeable sway, but I'll install a panhard this weekend, when I remove the wood floor.
Now that's the look I want.
Last edited by mrfliboy; 03-29-2017 at 04:39 PM.
|