View Single Post
Old 11-18-2016, 01:25 PM   #19
redmodelt
Senior Member
 
redmodelt's Avatar
 
Join Date: May 2010
Location: Portland OR
Posts: 6,339
Default Re: 1931 Tudor. Carburetor adjusting rod not turning

Could it be one of the needles made some years back that the shank that the end of the housing pinched on that was too large and you needed to remove the ring on the housing so the needle could freely turn in the housing. Not recommending this because the ring keeps the needle from changing on its own but if it helps in this case.
__________________
I know the voices aren't real but damn they have some good ideas!
redmodelt is offline   Reply With Quote