View Single Post
Old 05-11-2010, 08:54 PM   #9
Roadster62
Senior Member
 
Roadster62's Avatar
 
Join Date: May 2010
Location: Ridgefield, Ct
Posts: 3,439
Default Re: Installing Model A Ford == D == Shaped Nuts

Thank you Richard, I may have been overthinking this deal. I'd drilled a brass 10-32 screw for a wire that I planned to run the D nut with then tighten it down on a bridge washer I'd narrowed for MIG wire clearance. Your knot of wire will work better, and allow more welding room.
Roadster62 is offline   Reply With Quote