View Single Post
Old 06-25-2020, 05:50 PM   #19
duke36
Senior Member
 
Join Date: Jun 2015
Posts: 1,414
Default Re: Marvel Schebler carb pouring gas

Did you check the float submerged to see if air comes out a pinhole, as referenced in post 8 ? I've soldered holes after heating the float with a hair dryer or similar to dry it out.. It also only takes a spec or so from the tank / filter bowl to lodge in the valve tip. Some of us shut off fuel and run the carb almost dry at shutdowns.
duke36 is offline   Reply With Quote