View Single Post
Old 04-07-2021, 12:04 PM   #19
AnthonyG
Senior Member
 
AnthonyG's Avatar
 
Join Date: May 2013
Location: Pa.
Posts: 2,174
Default Re: Calculate actual quench height

Just wanted to report on results of ‘aluminum foil balls’ clearance check. Turned out .140 at center & .095 at edges. As the aluminum foil test shows more than enough clearance ( Probably too much), I’m still gonna go with it as stated earlier & agree with several poster’s, “If it ran OK before the Domes then it should run even more OK with them. Run it as-is & go from their”
Will report after I get it running.
__________________
Nomad
AnthonyG is offline   Reply With Quote