Quote:
Originally Posted by Bob Johnson
Here is the setup that I use. It does not have to have flowing water. I fill up the milk carton the to appropriate level before each test. I test for 1 minute. Because the milk carton has a large cross section at the height of the water level the drop after each test is a fraction of an inch and does not cause a problem. The rubber tubing I use has an inside diameter many times larger than the jets so it works fine.
Bob
 |
Yes, many variations are possible.
Nobody said that the water had to be flowing but my method always ensures that there is an accurate constant 36 inches head of water pressure that does not waver or drop. Based on my research of the Zenith carburetor plant and their methods, I feel that my rig will give test data every bit as accurate as the original factory method. But as with everything, to each his own. Thanks.