The Ford Barn - View Single Post

bdotson · 09-09-2011, 07:03 AM

OK how much shorter is the bell housing on the AA as compaired to the A? Useing the AA housing would move the trans forward by how much? What is the A bellhousing made from is it Cast iron? Could a new one be made from steel? I am asking because I dont know and am intrested in this conversion. If you have the AA bell housing do you have to shorten the input shaft on the transmission? If so how much do you have to respline the input and remachine the tip for the pilot bushing?

09-09-2011, 07:03 AM	#39
bdotson Member Join Date: May 2010 Posts: 59	Re: F150 tranny with overdrive OK how much shorter is the bell housing on the AA as compaired to the A? Useing the AA housing would move the trans forward by how much? What is the A bellhousing made from is it Cast iron? Could a new one be made from steel? I am asking because I dont know and am intrested in this conversion. If you have the AA bell housing do you have to shorten the input shaft on the transmission? If so how much do you have to respline the input and remachine the tip for the pilot bushing?