View Single Post
Old 09-22-2010, 06:56 AM   #5
Terry,OH
Senior Member
 
Terry,OH's Avatar
 
Join Date: May 2010
Posts: 4,729
Default Re: Removing ignition lock housings

this works well for 36 and later. most of the parts houses sell the retaining pin (approx 1/4" dia)for these lock cylinders. the retaining pin for the 32-35 cylinder is much smaller it is not sold by the parts houses and can be replaced by a #8 or #10 set screw. you will not be able to pull this small pin since it can not be center drilled and tapped for a pulling screw, just drill it out using the proper size drill for the size of set screw you have decided to use. use care to drill the entire pin by drilling straight through the pin and not at an angle.
Terry,OH is offline   Reply With Quote