The Ford Barn - View Single Post

john in illinois · 10-11-2015, 08:03 AM

I might add that I found a good tech article on the HAMB about tubing bending.
I wish I had seen this before I did mine.

http://www.jalopyjournal.com/forum/t...bender.993747/

John

10-11-2015, 08:03 AM	#18
john in illinois Senior Member Join Date: May 2010 Location: Illinois Posts: 2,183	Re: Brake question (hypothetical) I might add that I found a good tech article on the HAMB about tubing bending. I wish I had seen this before I did mine. http://www.jalopyjournal.com/forum/t...bender.993747/ John