View Single Post
Old 10-18-2020, 10:21 AM   #1
Magoo2
Member
 
Join Date: Nov 2017
Location: NJ
Posts: 54
Default King pin felt washer orientation

Just rebuilding front end of 31CCPU. What is the orientation of the felt washer and stamped cap on the bottom support? Does the stamped cap that surrounds the felt washer have the open side facing up or down. The new bottom bushings are longer than the support they are pressed into. Should the bushing protrude on the top or bottom of the support? They protrude about 1/16.
Magoo2 is offline   Reply With Quote