Re: I need help with turn signal switch
Measure the resistance between the black wire with red tracer to the switch case. If it is zero then it is a ground wire. If it has a few ohms it is for the indicator light. Most likely the indicator light. If I remember correctly I had to run a ground wire from the case to a ground point on the chassis.
The wiring diagram that Rotor Wrench supplied shows the blue wire going to the P terminal on the flasher and the black wire going to the T terminal. This may be reversed in your case, or not. Can you set this up on a bench to test it?
__________________
A is for apple, green as the sky.
Step on the gas, for tomorrow I die.
Forget the brakes, they really don't work.
The clutch always sticks, and starts with a jerk.
My car grows red hair, and flies through the air.
Driving's a blast, a blast from the past.
Last edited by nkaminar; 06-06-2022 at 10:00 AM.
|