al,
I will try to remember to tell Snyder's about the good folks here!
Seebees,
Point me to your thread if you have one too please. or post some pictures here.
Folks,
Leg cramps have me up in the middle of the night! So I thought I would check in
Looking at the Firestone 6.00-20 tires from Miller or Coker. Going to start with getting 3 here soon. Tires, tubes and flaps.
Will need to make masks for each side of each wheel if I get them sand blasted. the split ring will have to be blasted on just the tire side maybe?? Would like to keep as much of the barn find look as possible. Any other suggestions are welcome too.
Another small project is to weld up the gear shift positioning slot that is worn out and rework back to a slot, from a current "Y" shape. I will get a picture.
Regards,
Chris