Mitchell overdrive spline !!!
Thanks again for the previous advice I have received on Fordbarn.
I am proceeding with the rebuild of my rear end and I am trying to to a thorough job.
The double cone bearing race in the Banjo has been replaced also new bearings so the pinion preload must be set..
The car has a Mitchell overdrive and I am wanting to set the pinion preload as per "Tom Endy's Article.
The problem I have run into is trying to find the size of the 1/2 inch drive socket that will fit the Mitchel overdrive drive shaft spline.
I have a 1/2 inch drive beam torque wrench to do the job.
Does anyone know what size socket is required for the Mitchell spline and is it a six or 12 point socket ?
Thanks
Mark.
|