Quote:
Originally Posted by Mike Peters
I always punch the needed holes in the frame webbing while installing the webbing and then tie it in place with sewing thread to keep the webbing from moving. You tape idea is great and I'll try it the next time i do frame webbing.
Thanks for posting!
|
It is much easier to use a piece of EMT conduit and a propane torch to burn a hole right thru the anti-squeak. Use small spring clamps to hold the fabric to the frame, and heat the end of the conduit until red. Then sear the hole right thru the webbing. Way faster. Once the aprons or fenders are installed, no need for any adhesives.