Re: 1936 Pickup Grille Dimensions
Model 51 - Yes, I have the holes on the inner edge where the stainless trim would attached.
oldandtired - The grille pan attachment holes, on the bottom of the chin, are indicated on the drawing provided in my original post. These are center-to-center distance between the inner and outer sets of holes.
I have an aftermarket radiator and the side attachment measure-out to 22-1/4", which both shells measure at the top connection, so I assume that is the correct side-to-side measurement. I agree the lower three attachments to the fenders is where the action is. You will note that the shell with bars, (Thanks Lawson), struck something hard, but it has a good set of bars. The empty shell has had some body work, so I'm just not sure about the bend at the bottom of the chin, whether it's been compressed or not. Between the two of them I think I've got a good complete grille.
Attached are additional photos.
|