Quote:
Originally Posted by Marco Tahtaras
Thanks, does it look like there may be a felt just below the cup?
Ok, I was too slow. Did you blast away the felt?
|
In your post #34 the word "plug" had me thinking in 2 directions. Is that
your word or one off the prints? A "plug" for the "cup"? You follow me..
I, like you, thought the felt could be under the cup, "gravity feed", for
the shaft. Even with .010"-.015" clearance, shaft too housing, it would
be hard to wet the felt below. The dip stick is the perfect delivery tool
to oil the cup/oil hole/shaft.
The only stuff I found below the cup was
dirt, I dug it out, no blasting.
Of the 4-5 type 1 TA's that I have, none were sanded on top and no cups
or plugs.