The Ford Barn - View Single Post

d.j. moordigian · 11-16-2012, 08:01 PM

OK...more information, then I'm done for awhile...

1. The 2 piece forged that I have is not sanded on the top of the oil holes.

2. The 1 piece forged(I have 2) both are lightly sanded...1 with and 1 without cups.
And btw...the cups just don't fall out!

3. The holes in the top, for oil, is .250" (1/4"), including a type 4 assembly
that I have here. The type 4 is well sanded on the top, no cups.

11-16-2012, 08:01 PM	#45
d.j. moordigian Senior Member Join Date: May 2010 Location: Fresno, Ca. Posts: 3,636	Re: Second version of the throttle assembly OK...more information, then I'm done for awhile... 1. The 2 piece forged that I have is not sanded on the top of the oil holes. 2. The 1 piece forged(I have 2) both are lightly sanded...1 with and 1 without cups. And btw...the cups just don't fall out! 3. The holes in the top, for oil, is .250" (1/4"), including a type 4 assembly that I have here. The type 4 is well sanded on the top, no cups.