The Ford Barn - View Single Post

Jamie86 · 03-05-2012, 01:34 PM

john in illinois;379565 Here is a pic of my F150 with AA bell housing. No cutting of crossmember.

I fabricated the rear mount to isolate it from the crossmember.QUOTE

That looks like a good idea that you have done to help support the back of the transmission. Looks like you did a great job on it too.
Ken Parker of Van,TX did something similar to yours, but it supported by lip of the crossmember. He did it off the back of the transmission with two " L " pieces that are adjustable with rubber pads.

03-05-2012, 01:34 PM	#107
Jamie86 Member Join Date: Nov 2011 Location: Nashville,IN. Posts: 95	Re: F150 tranny with overdrive john in illinois;379565 Here is a pic of my F150 with AA bell housing. No cutting of crossmember. I fabricated the rear mount to isolate it from the crossmember.QUOTE That looks like a good idea that you have done to help support the back of the transmission. Looks like you did a great job on it too. Ken Parker of Van,TX did something similar to yours, but it supported by lip of the crossmember. He did it off the back of the transmission with two " L " pieces that are adjustable with rubber pads.