The Ford Barn - View Single Post

trctrdr · 09-09-2011, 08:04 AM

I have the short AA bell housing, although it's not yet installed, it looks like it will only require the pilot be shortened about a half inch.. This transmission has about i 3/16 inch pilot past the spline so I don't think any re-spline is needed. May need to just shorten the spline a little. When I get to that point I'll mount the trans. behind the engine without the clutch assy. to check this.

09-09-2011, 08:04 AM	#40
trctrdr Member Join Date: Aug 2010 Posts: 32	Re: F150 tranny with overdrive I have the short AA bell housing, although it's not yet installed, it looks like it will only require the pilot be shortened about a half inch.. This transmission has about i 3/16 inch pilot past the spline so I don't think any re-spline is needed. May need to just shorten the spline a little. When I get to that point I'll mount the trans. behind the engine without the clutch assy. to check this.