View Single Post
Old 07-26-2020, 12:34 PM   #17
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 860
Default Re: Decided to pull the motor/trans

Quote:
Originally Posted by Big hammer View Post
NO! #3 with the larger bores at 4inches need .004 clearance. The two back clylinders run hotter than the front two. I would make all four .004 clearance, Someone had problems with his engine seizing, after several tear downs he increased the bore clearances to .004 and his problem was solved.
Sounds reasonable. I haven't done the final finish hone yet so can easily add a thou or two. It would actually make me feel better anyway as .002 seems pretty tight to me. Thanks
Licensed to kill is offline   Reply With Quote