View Single Post
Old 07-26-2020, 10:06 AM   #14
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 860
Default Re: Decided to pull the motor/trans

Quote:
Originally Posted by katy View Post
Model T's do that, the top ring comes right to the top of the cylinder w/the piston sticking up above the block. Maybe the pistons you removed are like that?



Is .002" piston clearance enough on these engines?
The pistons are level with the deck @TDC so the top ring will be down a bit from that. I thought .002 was a bit tight also but that is the spec that I found and I looked for verification from a few different sources. All say .002.
Licensed to kill is offline   Reply With Quote