Re: 1930 Ford Sheetmetal Work
You clearly do nice work, but I have a question.
Why did you do the whole wheel well patch?
There was only a little bit of metal at the bottom that was bad.
From my experience it is fairly quick to make and weld in a a patch at the bottom of the wheel well. When you consider the length of the weld to do the whole arc and the cost of the panels. In the end I think you use less time and materials to make your own patch and weld it in.
I have encouraged several other people to make their own patches. In each case they have been surprised with how easy and quick the job went.
|