View Single Post
Old 10-05-2015, 08:15 PM   #204
haag1332
Senior Member
 
Join Date: Feb 2015
Posts: 120
Default Re: carburetor 13/32 deep well socket

Sorry guys,

I've been working on these just way more tedious than I thought. Coupled with a minor stay in the hospital last month and some cracked ribs last Sunday, lol, I am slowly but surely getting them done.

Actually I did rebroach them all and such. Just working on the stamping at this point. I am gonna try and make fixture right quick to speed this process up, as well as put a stop to the smashed fingers and numb tingling sensations, lol.

Once they are stamped I can rip through the heat treat and temper process, then ship.

Shouldn't be long now.

I know there are some of you who are new to this and have expressed interest. I will message you on here and confirm with you wether or not I can add you to the list within the next couple of days.

Hope everyone is doing well, and I sincerely appreciate the patience you have all shown with regard to this process.

Bill
haag1332 is offline   Reply With Quote