Quote:
Originally Posted by Art Newland
Not the draft tube, the little short one under the intake? I'm getting close to assembling a Canadian 8BA and need one. Don't see any of the dealers selling one. Worst case scenario, I'll find some small diameter exhaust pipe and split it and weld it. Seems like a lot of trouble tho.
|
If you cut that tube roughly in half, a Dorman 555-023 freeze plug will fit perfectly in the top end of that original bottom piece. Then, use a 3/8" compression bulkhead fitting such as this 3/8" compression bulkhead fitting (through freeze plug):
IMSBOLT.com #18090, or good parts store source, that will bolt through a hole drilled in the freeze plug. See our PCV/8BA complete thread with pictures and parts list at this link below. DD
https://www.fordbarn.com/forum/showt...=pcv+valve+8ba
