[OldGold360]

I am going to be making some fender repair pieces. Just about finished with tooling for the wheel opening bead. I’ll definitely be making the inner reinforcement piece for the lower front section of the rear fenders. I’ve got a good one from my fender so I will be able to match it perfectly. I’ll see what I can do on the outer portion where it mates to the running board. I do need to play around with cab corners a bit. Ive been asked by others about making some. They would be shaped rather than stamped so I need to figure out how to do it quickly. Im working on lower outside cowl sections now for anybody interested. I will be trying to have these available after this weekend. Thanks