The Ford Barn - View Single Post

alexiskai · 06-10-2021, 08:54 AM

I wrote to JB Weld and they recommended using the original epoxy, which is good up to 550°. So I think I'm gonna go that direction since I already have that.

I'm planning to use an original manifold, but this intake doesn't have the transfer plate, so it'll have to be via convection and radiation instead.

06-10-2021, 08:54 AM	#15
alexiskai Senior Member Join Date: Apr 2018 Location: Mebane NC Posts: 2,357	Re: Filler putty for aluminum intake? I wrote to JB Weld and they recommended using the original epoxy, which is good up to 550°. So I think I'm gonna go that direction since I already have that. I'm planning to use an original manifold, but this intake doesn't have the transfer plate, so it'll have to be via convection and radiation instead.