Quote:
Originally Posted by PeteVS
I've been buying good bits when I go to Hershey. I think it's "Drill Bit City" and they're located in the mid-west. They bits I've been buying cut like crazy and they have 3 small flats ground on the shank so they can't slip in the chuck. Here's a link:
http://drillcity.stores.yahoo.net/
|
If you will tighten up all three holes in the chuck of your drill press or hand drill you won't have to worry about them slipping. This also keeps the chuck from scratching off all the info on the base of the bit about what size etc. the bit is.